Inserting/Changing The Needle - DURKOPP ADLER 581 Operating Instructions Manual

Operation
Operating Instructions 581 - 02.0 - 05/2019
Deactivating threading mode
To deactivate threading mode:
1. Press the button (1) again. The button must disengage.
 After a short pause, the machine is ready to sew again.
The sewing process is continued from the point where
threading mode was activated.
4.4

Inserting/changing the needle

WARNING
Risk of injury from sharp parts!
Puncture possible.
Only change the needle with the machine
switched off.
Fig. 7: Inserting/changing the needle (1)
①
(1) - Screw
To insert or change the needle:
1. Loosen the screw (1).
2. Pull the needle (2) from the needle bar.
3. Insert the new needle into the hole in the needle bar until it
reaches the end stop.
(2) - Needle
②
23