Adjusting The Cutting Mode - DURKOPP ADLER 581 Operating Instructions Manual

70
5.2.6

Adjusting the cutting mode

On the display, the field (1) indicates the cutting mode.
The cutting mode determines when and whether a buttonhole
is to be cut during the sewing process.
For cutting mode, you can switch between the following
parameters:
Parameters for cutting mode
Parameter Function
= No cutting
0
= Cut after the seam end (Cut After)
CA
= Cut before the seam beginning (Cut Before)
CB
Fig. 50: Adjusting cutting mode in sequential mode
(1) - Cutting mode
To adjust the cutting mode:
1. Use the button to navigate to the field Cutting mode (1).
2. Press the
 The cursor flashes.
3. Use the buttons
4. Confirm with the
button.
or to set the desired value.
button.
Operating Instructions 581 - 02.0 - 05/2019
Programming
①