Inserting The Reinforcement Strip - DURKOPP ADLER 755 Additional Instructions

Tape feeder

2.4 Inserting the reinforcement strip

Fig. 9: Inserting the reinforcement strip (1)
(1) - Guide
(2) - Tape monitor
(3) - Advancing device
To insert the reinforcement strip:
1. Pull the knurled screw (6) and the disk (5) off to the side.
2. Insert the tape roll.
3. Place the disk (5) and tighten it using the knurled screw (6).
4. Feed the reinforcement strip (4) from bottom to top through the advanc-
5. Insert the reinforcement strip (4) into the guide (1) behind the tape
Additional Instructions 755/756 - 00.0 - 10/2018
①
②
③
④
Follow the tape puling direction.
Ensure that the disk (5) clamps the tape roll securely.
ing device (3).
monitor (2).
(4) - Reinforcement strip
(5) - Washer
(6) - Knurled screw
⑥
⑤
11