Mounting Plate; Roll Paper Stand; Figure 40 Tt-3608A Paper Roll Stand - Thrane&Thrane SAILOR TT-3000E mini-C GMDSS System Installation Manual

TT-3000E mini-C GMDSS System
4.6.1 M
OUNTING PLATE
A mounting plate is supplied with the TT-3608A Hard Copy
Printer, for horizontally oriented secured mounting see
section 4.6.3.
4.6.2 R P
OLL
Figure 39 TT-3608A Paper Roll Stand
A roll paper stand is available for the TT-3608A Hard Copy
Printer. This enables the printer to signal an advanced
warning of a paper low condition, when the paper roll is
almost empty. The printer continues to work, and "Printer
almost out of paper" message is displayed by the message
terminal. When a "Printer almost out of paper" condition occur
the audio alarm will sound and the fault indication on any
connected alarm panel will be switched on - these indications
continues until the paper roll is replaced.
If the printer is set off-line using the "select" button or
powered off using the power switch, the audio alarm and the
fault indication in the alarm panels will be switched on.
The DIP switch 8 "ROLL PAPER STAND" in the printer, must be
set to OFF, which selects roll paper stand, and the roll paper
stand connector must be attached to the back of the printer
S
APER TAND
63/97
Installation Manual