1. Installation
1.2.2 Opening and closing the CPV valve terminal
1.2.3 Setting and saving the station number with automatic mode
1−6
Opening the switch cover
Unscrew and remove the 4 screws in the switch cover. Lift the
cover upwards.
Closing the switch cover
Replace the cover. Insert and tighten the 4 screws in diag
onally−opposite sequence.
The station number can be set with the following devices:
The Handheld Activator for the Honeywell Smart
Distributed System or
A suitable Smart Distributed System master.
Please note
Do not connect the Handheld activator directly to the CPV
valve terminal.
The power supply of a battery−operated Handheld Activator is
not sufficient for setting the station number of a CPV valve
terminal. Connect the Handheld Activator to an unused posi
tion in the bus system, e.g. to a service tap.
The station number (= SDS−ID) is stored in a non−volatile
memory in the CPV valve terminal. The station number can be
modified at any time. The station number last entered re
mains stored in the CPV valve terminal.
Example:
Setting and saving the station number with the Honeywell
Handheld Activator
Festo P.BE−CP−SD8−...−EN en 0503b