Electrical Safety; General Guidelines; Power Cord - Xerox B1025 User Manual

Electrical Safety

G G e e n n e e r r a a l l G G u u i i d d e e l l i i n n e e s s
WARNING:
• Do not push objects into slots or openings on the printer. Touching a voltage point or
shorting out a part can result in fire or electric shock.
• Unless you install optional equipment and are instructed to do so, do not remove the covers
or guards that are fastened with screws. Before you perform these installations, power off
the printer. When you remove covers and guards to install optional equipment, disconnect
the power cord. Except for user-installable options, there are no parts that you can maintain
or service behind these covers.
WARNING: The following are hazards to your safety:
• The power cord is damaged or frayed.
• Liquid is spilled into the printer.
• The printer is exposed to water.
• The printer emits smoke, or the surface is unusually hot.
• The printer emits unusual noise or odors.
• The printer causes a circuit breaker, fuse, or other safety device to activate.
If any of these conditions occur, do the following:
1. Power off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
P P o o w w e e r r C C o o r r d d
Use the power cord supplied with your printer.
• Do not use an extension cord, or remove or modify the power cord plug.
• Plug the power cord directly into a properly grounded electrical outlet. Ensure that each end of the
cord is connected securely. If you do not know if an outlet is grounded, ask an electrician to check
the outlet.
• Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have
a ground connection terminal.
WARNING:
grounded properly. If misused, electrical devices can be hazardous.
• Verify that the printer is plugged into an outlet that provides the correct voltage and power. If
necessary, review the electrical specification of the printer with an electrician.
• Do not place the printer in an area where people can step on the power cord.
• Do not place objects on the power cord.
• Replace a frayed or worn power cord.
To avoid the potential of electrical shock, ensure that the printer is
Xerox ® B1025 Multifunction Printer
Safety
11
User Guide