Table of Contents
Advertisement
•
P8 = Hardness;
•
P9** = Units of measurement;
•
P10** = Clock mode.
* Calculated by software, modifiable to fine tune softener operation.
** Pre-selected by World model (i.e. 220-230 VAC, 50 Hz, metrics unit).
5.5.1. Regeneration cycles time
Press and hold the
time programming.
→ A small "C#" with a number will be displayed indicating the controller is in cycle time
programming.
→ The number indicates the cycle being viewed or changed.
C1-Backwash
C2*-Brine Draw
C3*-Slow Rinse
C4-Re-pressurize
* The cycles time are pre-selected by the software based upon the programmed volume of resin and salt dosage. Cycle time
are not modifiable. During the regeneration, the controller will display C2 for the entire duration of C2+C3. The effective
difference between brine draw and slow rinse will be hydraulically done when the valve air-check's closes once all the brine
have been drawn.
NOTE
See chapter 3.1.2. System service & regeneration cycles (7-cycles operation), page 16 for
more information about cycles.
Salt
Cycle
setting
L
C1
S
H
L
C2
S
H
L
C3
S
H
Ref. MKT-IM-037 / B - 17.12.2018
and
for 5 seconds when the controller is not in regeneration to enter cycle
Evolio 255 10L
Evolio 255 15L
8 min
4.7 min
9.4 min
18.9 min
11.7 min
33.9 min
33.9 min
Installer Manual Evolio 255 - Programming
C5-Rapid Rinse
C6-2nd Backwash
C7-2nd Rapid Rinse
C8*-Refill
Evolio 255 20L
8 min
14 min
5.2 min
6.3 min
15.5 min
17.6 min
25.8 min
27.7 min
17 min
18.7 min
49.3 min
54.2 min
49.3 min
54.2 min
Evolio 255 30L
14 min
7.3 min
18.9 min
31.5 min
17.8 min
51.7 min
51.7 min
47 / 90
Advertisement
Table of Contents
