Table of Contents
Advertisement
7. "PM"
8. "MIN"
9. "g/L"
10. "KG"
11. "x100"
3
12. "Lbs/ft
"
13. Faucet
14. Maintenance interval
15. Digits
16. Number
17. History values (H)
18. Parameter (P)
19. Cycle (C)
20. "x2"
21. Hardness
22. Capacity
23. Regen icon
24. Salt setting
25. Regeneration time
26. Time of day
Ref. MKT-IM-037 / B - 17.12.2018
Indicates that the time displayed is between 12:00 noon and 12:00
midnight.
"PM" indicator is not used if the clock mode is set to 24-hour (there is
no PM indicator).
Indicates that the value entered/displayed is in minute increments.
Indicates that the value entered/displayed is in grams/Liter.
Indicates that the value entered/displayed is in kilograms or kilograins,
depending on selected unit mode in P9, see 5.5. Advanced
programming, page 46.
x100 multiplier for large values.
Indicates that the value entered/displayed for regenerant amount is in
pounds per cubic foot.
Appears when the current flow rate is displayed.
The controller may show the faucet and "0", indicating no flow.
Displayed when the duration in month since last maintenance exceed
the value programmed in parameter P11.
Four digits used to display the time, program value or error codes.
Used with #19, #21 and #22.
Displays a sequence number or value.
The number displayed by #18 identifies which history value is currently
displayed.
Displayed only in advanced programming.
The number displayed by #18 identifies which parameter is currently
displayed.
The number displayed by #18 is the current cycle in the regeneration
sequence.
Indicates a second regeneration has been called for.
Hardness setting in mg/L as CaCO
Shows estimated system capacity.
Flashes when a regeneration at the next time of regeneration has been
called for.
Also displayed (continuously) when in regeneration.
Programming the amount of salt used for a regeneration.
Programming the time of regeneration.
Programming the current time of day.
Installer Manual Evolio 255 - Programming
or ppm.
3
39 / 90
Advertisement
Table of Contents
