Batch" Operating Mode Settings (Batch Menu); Programmable Function Settings (Set Menu ) - ProMinent SCKa Series Operating Instructions Manual

Set up
"Memory" function extension

8.5.4 "Batch" operating mode settings (BATCH menu)

"Memory" function extension

8.6 Programmable function settings (SET menu )

34
You can also activate the "Memory" function extension (identifier
appears on the LCD screen;
vated, the pump software adds up the remaining strokes , which could not
be processed, up to the maximum capacity of the stroke memory of
65,535 strokes. If this maximum capacity is exceeded, the pump goes into
fault mode.
You can thus optimally match the pump to the process in question, for
example in conjunction with contact water meters.
Alongside those described in more detail in the chapter "Programmable
function settings (SET menu)" the
'Batch' operating mode via the 'SET' menu.
Continuous
display
Fig. 25
'Batch' is a variant of the operating mode 'Contact' -
The operating mode
'Contact' operating mode settings". Here also, you
in the first place see "
can select a number of strokes (no fractions, only integers from 1 to
65535), but also a metering quantity (Batch). To change between the input
"Number of strokes" and "Metering quantity" press the
the corresponding menu option (see "Operating / adjustment overview" in
the appendix).
'Batch' operating mode is intended for large metering quantities.
The metering can be triggered either by pressing the
received via the "External control" terminal.
The number of received pulses, which could not yet be processed, is
stored by the pump control in the stroke memory. The stroke memory is
limited to the Batch size if "Memory" is not activated, with "Memory" to
65535 strokes.
You can delete it by changing to another operating mode.
You can also activate the "Memory" function extension (identifier
appears on the LCD screen;
vated, the pump software adds up the remaining strokes , which could not
be processed, up to the maximum capacity of the stroke memory of
65,535 strokes. If this maximum capacity is exceeded, the pump goes into
fault mode.
You can thus optimally match the pump to the process in question, for
example in conjunction with contact water meters.
Setting menus are available in the SET menu in all operating modes for
the following programmable functions:
'CALIB' menu)
Calibrate (
n
'AUX' menu)
Auxiliary rate (
n
'FLOW' menu; (only available if a dosing monitor is connected)
Flow (
n
'Mem' = memory). When "Memory" is acti‐
'BATCH' menu is also available in
[ i ] key 1x under
[P] key or by a pulse
'Mem' = memory). When "Memory" is acti‐
'Mem'
B0092
'Mem'