Ce Labelling - Danfoss VLT AQUA Drive Design Manual

2. Introduction to VLT AQUA Drive
2.1.2. Caution
The frequency converter DC link capacitors remain charged after power has been disconnected. To avoid an electrical shock hazard,
disconnect the frequency converter from the mains before carrying out maintenance. Wait at least as follows before doing service on
2
the frequency converter:
Voltage
200 - 240 V
380 - 480 V
525-600 V
525-690 V
Be aware that there may be high voltage on the DC link even when the LEDs are turned off.
2.2. Software Version
2.2.1. Software Version and Approvals
This manual can be used with all VLT AQUA Drive frequency converters with software version 1.24.
The software version number can be found in parameter 15-43.

2.3. CE labelling

2.3.1. CE Conformity and Labelling
What is CE Conformity and Labelling?
The purpose of CE labelling is to avoid technical trade obstacles within EFTA and the EU. The EU has introduced the CE label as a simple way of showing
whether a product complies with the relevant EU directives. The CE label says nothing about the specifications or quality of the product. Frequency
converters are regulated by three EU directives:
The machinery directive (98/37/EEC)
12
4 min. 15 min.
0.25 - 3.7 kW 5.5 - 45 kW
0.37 - 7.5 kW 11 - 90 kW
0.75 kW - 7.5 kW
Equipment containing electrical components may not be disposed of together with domestic waste.
It must be separately collected with electrical and electronic waste according to local and currently valid
legislation.
VLT AQUA Drive
Software version: 1.24
MG.20.N4.02 - VLT
Min. Waiting Time
20 min.
110 - 250 kW
110 - 250 kW
45 - 400 kW
®
is a registered Danfoss trademark
®
VLT AQUA Drive Design Guide
30 min.
315 - 450 kW
315 - 560 kW
450 - 630 kW