Danfoss VLT AQUA Drive Design Manual page 79

®
VLT AQUA Drive Design Guide
How to add the MCO 101 option:
• The power to the frequency converter must be disconnected.
• The power to the live part connections on relay terminals must be disconnected.
• Remove the LCP, the terminal cover and the cradle from the FC 202.
• Fit the MCO 101 option in slot B.
• Connect the control cables and relief the cables by the enclosed cable strips.
• Various systems must not be mixed.
• Fit the extended cradle and terminal cover.
• Replace the LCP
• Connect power to the frequency converter.
Wiring the Terminals
Do not combine low voltage parts and PELV systems.
®
MG.20.N4.02 - VLT is a registered Danfoss trademark
3. VLT AQUA Selection
3
79