Diagnostics Via Parameters - Siemens SINAMICS GM150 Operating And Installation Instructions

LEDs of the DM10 diagnostics module
The LEDS installed on the diagnosis module indicate the logic state of the signals present
between the communication partners of the DM10 diagnosis module.
Table 8-10 LEDs of the DM10 diagnostics module
LED Communication partner
H30 -X232/-X32
H31 -X232/-X32
H32 -X232/-X32
H33 -X232/-X32
H34 -X33/-X5
H35 -X33/-X5
H36 -X33/-X5
H37 -X33/-X5
H20 -X34/-X36
H21 -X34/-X36
H22 -X35/-X36
H23 -
8.5.3.3

Diagnostics via parameters

Diagnostic parameters for the device status
r0002 Drive status
Display of drive status
r0046 Missing enable signals
Display of the missing enable signals that are preventing the drive control from being commissioned
Bit Signal name
00 OFF1 enable missing
01 OFF2 enable missing
02 OFF3 enable missing
03 Enable run missing
05 External power-on inhibit active
06 Commissioning not yet complete
09 Infeed enable missing
10 Ramp-function generator enable missing
11t No start ramp-function generator
12t No setpoint enable
16 OFF1 internal enable missing
17 OFF2 internal enable missing
SINAMICS GM150 6SL3815-2LN41-4AA2
Operating Instructions 04/2017
Meaning: signal 1 / signal 0
Control signals from PSA present / not present
Control signals from PSA present / not present
Control signals from PSA present / not present
Control signals from PSA present / not present
Binary plant signals for diagnosis on PADU8 present / not present
Binary plant signals for diagnosis on PADU8 present / not present
Binary plant signals for diagnosis on PADU8 present / not present
Binary plant signals for diagnosis on PADU8 present / not present
Internal power supply 1P24 OK / not OK
Internal power supply 1N24 OK / not OK
External power supply 2P24_1 and 2P24_2 OK / 2P24_1 or 2P24_2 not OK
Internal and external power supplies OK / not OK
Operation
8.5 Fault and system messages
0-signal 1-signal
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
187