Possible Causes And Remedies In Case Of Unsatisfactory Welding Results - Elektron MULTISPOT MI-100control Operating Manual

7.2.3

Possible causes and remedies in case of unsatisfactory welding results

Symptom
Weld spot too small
Welding spot burns up,
excessive spattering,
sheets not strong enough.
Welding job flawed
Possible cause
Weld current too weak.
Weld time too short.
Wrong welding program.
Weld current too high.
Weld time too long.
Wrong welding program.
Welding parameters not set correctly
according to requirements.
Sheets may have been insufficiently
prepared.
Setting / operating error(s) within the
operating mode set.
Resistance welder MULTISPOT MI-100control
Remedy
Adapt welding parameters.
If that doesn't do it, fall back
on pre-defined programs
and / or keyboard mode.
Select correct welding
program.
If in doubt, talk to the
manufacturer and / or OEM.
Adapt welding parameters.
If that doesn't do it, fall back
on pre-defined programs
and / or keyboard mode.
Select correct welding
program. If in doubt, talk to
the manufacturer and / or
OEM.
Use the "Info" button to call
up the values set. Compare
to your specs.
"6.1.1"
"6.4.2" If in doubt,
contact manufacturer.
Troubleshooting
WHO should
do it?
Operator
Operator
Operator
Operator
Operator
Operator
Operator
79