Changing Configuration; Loading Most Recent Configuration - Elektron MULTISPOT MI-100control Operating Manual

Fig. 81: Cap service activated
6.7.2.2

Changing configuration

Fig. 82: Changing the configuration
6.7.2.3

Loading most recent configuration

Resistance welder MULTISPOT MI-100control
You will see the message shown here on the left.
Use the menu item "Change configuration" to carry out
changes to the configuration. You need appropriate access
rights.
In addition, you need an "Expert" CF memory card.
If no "Expert" CF memory card has been slotted, you will see
the message shown here on the left.
With the menu item "Load last configuration", you can
restore the most recent configuration used.
If the new configuration fails, the system will automatically
revert to the previous version.
Use the control knob to select "Load last configuration".
Press to confirm.
Operation
61