Elektron MULTISPOT MI-100control Operating Manual page 55

There is a danger the equipment rolls away because the wheels must not be blocked due to the
tipping and toppling hazard
CAUTION!
The wheels of the equipment must not be blocked because this would cause a tipping
and toppling hazard. On the other side, though, this detail causes and increases the
danger the equipment rolls away.
Therefore:
Be sure to operate this equipment only on a flat and even floor.
Proceed with care when moving this equipment.
Personal protective equipment (PPE)
When working, always wear:
Safety clothing
...is a tight-fitting sort of special clothing that is not inflammable, covers arms and legs
completely and tears easily (instead of getting pulled in).
Its main purpose is to protect against burns.
Safety shoes
...protect the wearer's feet against falling objects, slippery surfaces and being run over
by vehicles.
For special works wear:
Face screen
...protects the face and eyes against splashes, flying sparks and other hot particles.
Welder's gloves
...protect the hands against splashes, flying sparks and other hot particles, and prevent
contact with hot surfaces.
Never use wet welder's gloves.
Furthermore
...no long hair, rings, necklaces, watches and / or other sorts of jewellery. Do not carry
easily inflammable objects in your pockets (matches, lighters etc.).
Be sure to be always wearing the appropriate PPE for the job at hand.
Be sure to take note of and comply with warning signs concerning PPE that may be installed
at the workplace.
Equipment rolling away may cause damage to property!
Resistance welder MULTISPOT MI-100control
Operation
55