On The Balancer; On The Control Board; Spare And Wear Parts - Elektron MULTISPOT MI-100control Operating Manual

Resistance welder MULTISPOT MI-100control
Health and safety
2.7.3

On the balancer

Fig. 5: Warning sign on balancer
Danger of tipping by relatively high centre of gravity and any obstacles in the path
2.7.4

On the control board

Fig. 6: Warning sign on the control board
2.8

Spare and wear parts

Be sure to buy your spare and wear parts directly from the manufacturer or an authorised dealer.
For contact information
20
CAUTION! Tipping and toppling may cause damage to property!
This equipment's centre of gravity is relatively high. In the event the wheels jam and / or
block (due to an obstacle or transverse pull, for instance), there is a danger the
equipment tips over.
Therefore:
Move this equipment always using the handles.
Keep potential obstacles out of the work area.
Install cables and supply lines in such a way that they do not constitute a stumbling
trap.
WARNING! Wrong spare and wear parts constitute a hazard!
Wrong and / or defective spare and wear parts may constitute a safety hazard and may
entail errors, damage and even total destruction.
Therefore:
Always use genuine spare and wear parts made by the manufacturer.
see page 2 of this manual or the service menu on the control panel.
Meaning
Always pull in the direction the guiding wheels are pointing.
In the event of lateral and / or transverse pull, there is a
danger the wheels jam / block and the equipment tips over.
Meaning
Do not pull compact flash card unless equipment has been
properly switched off.
Compact flash card might be destroyed otherwise.