SSS Siedle DoorCom Analog Series Programming Instructions Manual page 4

Brief instructions
Manual initial configuration
Procedure
Press the programming button on
the BNG/BVNG 650-... The "Door
loudspeaker enable" display flashes.
On the door station, press and hold
the light/programming button for
4 seconds until a sustained tone
can be heard from the door loud-
speaker:
• Siedle Vario: Light button
• Siedle Classic: Programming
button (through opening in the
speech grille)
• Siedle Steel: Programming button
(below the front panel)
• Siedle custom-fit door loud-
speaker: Programming button next
to the terminals
Press the OK button.
Optionally
(Setting up a parallel call)
If an indoor station is to be called
in parallel with this DCA user, this
must be set up now during manual
programming. Only one indoor sta-
tion can be set up per DCA user via
manual programming. Parallel video
indoor stations require an additional
supply here.
Indoor stations with receiver
Lift the receiver at the bus tele-
phone which you wish to program.
Hold down the light button for
4 seconds. A protracted signal tone
is audible in the receiver. A speech
connection exists to the door sta-
tion. The indoor station is now in
programming mode.
Do not replace the receiver!
Indoor station without receiver
• Standard/Comfort device series:
Hold the light button for 4 seconds.
A sustained signal tone sounds and
the muting button flashes. There
is a speech connection to the door
station. The indoor station is now in
the programming mode.
4
Function button(s)
OK
Display indicator
Door loudspeaker
enable
Door loudspeaker
activated
Assign call btn.
for user 1