Ip21/Type 1 Enclosure Kit - Danfoss VLT HVAC Basic Drive FC 101 Design Manual

Selection
Step 3
Place bracket on back of the LCP, then slide down.
Tighten screws and connect cable female side to LCP.
3 3
Figure 3.3 Place Bracket on LCP
Step 4
Connect cable to adjustable frequency drive.
Figure 3.4 Connect Cable
46
Design Guide
NOTICE!
Use the provided thread cutting screws to fasten
connector to the adjustable frequency drive, tightening
torque 11.51 in-lb [1.3 Nm].

3.1.3 IP21/TYPE 1 Enclosure Kit

IP21/TYPE 1 is an optional enclosure element available for
IP20 units.
If the enclosure kit is used, an IP20 unit is upgraded to
comply with enclosure IP21/TYPE 1.
Danfoss A/S © Rev. 2014-01-14 All rights reserved.
C
On
Warn.
Alarm
Figure 3.5 H1-H5
B
MG18C522