Error Messages - DURKOPP ADLER 827-M Operating Manual

96

10.2.2 Error messages

Code Possible cause
1000 Sewing motor encoder
plug (Sub-D, 9-pin) not
connected
1001 Sewing motor error:
Sewing motor plug (AMP)
not connected
1002 Sewing motor insulation
fault
1004 Sewing motor error:
Incorrect sewing motor
direction of rotation
1005 Motor blocked
1006 Maximum speed exceeded
1007 Error in the reference run
1008 Encoder error
Remedial action
• Connect encoder cable to the
control, use correct connection
• Check connection and plug in,
if necessary
• Test sewing motor phases
(R = 2.8 Ω, high impedance
to PE)
• Replace the encoder
• Replace sewing motor
• Replace the control
• Check motor phase and PE for
low-impedance connection
• Replace the encoder
• Replace sewing motor
• Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine
distributor and change it,
if necessary
• Test motor phases and check
for correct value
• Eliminate stiff movement in the
machine
• Replace the encoder
• Replace the motor
• Replace the encoder
• Perform reset
• Check class
(parameter t 51 04)
• Replace the encoder
• Eliminate stiff movement in the
machine
• Replace the encoder
Operating Instructions 827/827-M - 01.0 - 02/2019
Troubleshooting