Table of Contents
Advertisement
Setup
Operating Instructions 827/827-M - 01.0 - 02/2019
To assemble the tabletop and the pedal to the stand:
1.
Drill holes for the wood screws.
2.
Using wood screws (6x30), assemble the stand (2) to the
tabletop (1). Observe the center marks for the stand
(see Appendix ( p. 105)).
3.
Erect the stand (2).
4.
Slip the rod (6) onto the pedal (4) and the setpoint device.
5.
For ergonomic reasons, align the pedal laterally so that the
center of the pedal is directly below the needle.
The cross strut (5) is provided with slotted holes to allow align-
ment of the pedal (4).
6.
Loosen the screw (3).
7.
Adjust the height of the rod (6) so that the slope of the released
pedal is approx. 10°.
8.
Tighten the screw (3).
9.
Insert the reel stand (7) into the hole in the tabletop (1) and
secure it with a nut and washer.
10. Align thread reel holder and thread guide.
Important
The thread guide must be positioned vertically above the thread
reel holder.
69
Advertisement
Table of Contents
