Table of Contents
Advertisement
36
4.10 Roller top feed
Fig. 16: Roller top feed
①
②
(1) - Lever
(2) - Carrier roller
The feed length of the roller top feed can be set to a different length
of up to 9 mm relative to the bottom feed using the adjusting
wheel (3).
After the machine has been switched on, the carrier roller (2) is
lowered.
After the sewing foot has been lifted, the carrier roller (2) is raised.
If programmed, the stitch count begins upon the start of the
seam ( p. 49).
If the start bartack is switched on, the stitch count will not start
until after the start bartack.
Switching on the roller top feed
To switch on the roller top feed:
1.
Push the lever (1) down.
The carrier roller (2) descends onto the sewing material.
(3) - Adjusting wheel
Operating Instructions 827/827-M - 01.0 - 02/2019
Operation
③
Advertisement
Table of Contents
