Motorola MVME2300 Series Installation And Use Manual page 138

Troubleshooting
Condition
C
V. The debugger is
in system mode
and the board
autoboots, or the
board has passed
selftests.
VI. The board has
failed one or more
of the tests listed
above, and cannot
be corrected using
the steps given.
C-4
Table C-1. Troubleshooting Problems (Continued)
Possible Problem
A. No apparent
problems —
troubleshooting is
done.
A. There may be
some fault in the
board hardware or
the on-board
debugging and
diagnostic
firmware.
TROUBLESHOOTING PROCEDURE COMPLETE.
Possible Resolution:
6. You may need to use the cnfg command (see
your board Debugger Manual) to change clock
speed and/or Ethernet Address, and then later
return to:
env <CR>
and step 3.
7. Run the selftests by typing in:
st <CR>
The tests take as much as 10 minutes, depending on
RAM size. They are complete when the prompt
returns. (The onboard selftest is a valuable tool in
isolating defects.)
8. The system may indicate that it has passed all the
selftests. Or, it may indicate a test that failed. If
neither happens, enter:
de <CR>
Any errors should now be displayed. If there are
any errors, go to step VI. If there are no errors, go
to step V.
No further troubleshooting steps are required.
1. Document the problem and return the board for
service.
2. Phone 1-800-222-5640.
Computer Group Literature Center Web Site