Pmcs; Pmcspan; System Console Terminal - Motorola MVME2300 Series Installation And Use Manual

Preparation and Installation
1

PMCs

PMCspan

System Console Terminal

1-12
For a discussion of any configurable items on the PMCs, refer to the user's
manual for the particular PMCs.
You need to use an additional slot in the VME chassis for each PMCspan
expansion module you plan to use. Before installing a PMCspan on the
MVME2300, you must install the selected PMCs on the PMCspan. Refer
to the PMCspan PMC Adapter Carrier Module Installation and Use
manual for instructions.
Make sure that jumpers are installed on all bits on header J17 of the
MVME2300 board as shown in
PPCBug firmware is used. Connect the terminal via a cable to the RJ45
DEBUG connector J2.
See
Appendix B, Connector Pin Assignments
Set up the terminal as follows:
– Eight bits per character
– One stop bit per character
– Parity disabled (no parity)
– Baud rate = 9600 baud (default baud rate of the port at power-
up). After power-up, you can reconfigure the baud rate with
PPCBug's PF command
Figure 1-2. This is necessary when the
for pin signal assignments.
Computer Group Literature Center Web Site