Motorola MVME2300 Series Installation And Use Manual page 40

Preparation and Installation
1
!
Caution
!
Warning
1-20
Inserting or removing modules with power applied may result in damage
to module components.
Avoid touching areas of integrated circuitry; static discharge can damage
these circuits.
Dangerous voltages, capable of causing death, are present in this
equipment. Use extreme caution when handling, testing, and
adjusting.Proceed as follows to install the MVME2300 in the VME
chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown:
– Turn the AC or DC power off and remove the AC cord or DC
power lines from the system.
– Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
3. Remove the filler panel from the card slot where you are going to
install the module. If you have installed one or more PMCspan PCI
expansion modules onto your module, you will need to remove filler
panels from one additional card slot for each PMCspan, above the
card slot for the module.
– If you intend to use the module as system controller, it must
occupy the left-most card slot (slot 1). The system controller
must be in slot 1 to correctly initiate the bus-grant daisy-chain
and to ensure proper operation of the IACK daisy-chain driver.
– If you do not intend to use the module as system controller, it can
occupy any unused card slot.
4. Slide the module (and PMCspans if used) into the selected card
slot(s). Be sure the module or modules is/are seated properly in the
P1 and P2 connectors on the backplane. Do not damage or bend
connector pins.
Computer Group Literature Center Web Site