Motorola MVME2300 Series Installation And Use Manual page 137

Table C-1. Troubleshooting Problems (Continued)
Condition Possible Problem
IV. Debug prompt A. The initial
debugger
PPC1-Bug>
appears at environment
powerup, but the parameters may be
board does not set incorrectly.
autoboot.
B. There may be
some fault in the
board hardware.
C-3
Possible Resolution:
1. Start the onboard calendar clock and timer. Type:
set mmddyyhhmm <CR>
where the characters indicate the month, day, year,
hour, and minute. The date and time will be
displayed.
!
Caution
Performing the next step (env;d) will change some
parameters that may affect your system's operation.
2. At the command line prompt, type in:
env;d <CR>
This sets up the default parameters for the debugger
environment.
3. When prompted to Update Non-Volatile RAM, type in:
y <CR>
4. When prompted to Reset Local System, type in:
y <CR>
5. After clock speed is displayed, immediately (within five
seconds) press the Return key:
<CR>
or
BREAK
to exit to the System Menu. Then enter a 3 for "Go to System
Debugger" and Return:
3 <CR>
Now the prompt should be:
PPC1-Diag>
Solving Startup Problems
C