Setting The Stroke Movement For The Feeding Foot - DURKOPP ADLER H-Type 969 Service Instructions Manual

Cover
• Arm cover ( p. 11).
• Head cover ( p. 12).
Fig. 43: Aligning the feed stroke of the feet
①
②
③
④
(1) - Presser foot
(2) - Sewing foot
(3) - Distance piece
Setting steps
1. Move the handwheel into the 0° position ( p. 20).
2. Set stitch length to 0.
3. Adjust the zero stroke of the feet ( p. 59).
4. Loosen the screw (5).
5. Place the plate (4) and distance piece (3) under the feet as illustrated
6. Manually move both feet down as far as they will go.
7. Tighten the screw (5).

11.4 Setting the stroke movement for the feeding foot

62
so that the sewing foot (2) is 0.3 mm lower than the presser foot (1).
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
sharp and moving parts.
Switch the machine off before you check and set
the stroke movement for the feeding foot.
Adjusting the sewing foot feed
(4) - Plate
(5) - Screw
Service Instructions 969 - 01.0 - 12/2015
⑤