Class Exercises - Keysight Technologies B1500A Self-Paced Training Manual

Class Exercises

Class exercises use the test setup listed below. The test setup data are only examples and
included in the Demo.xpg file stored in Keysight B1500 Series Product Reference
CD-ROM.
Module
Module 1 no exercise
Module 2 Id-Vd measurement
Id-Vd measurement
Id-Vd measurement
SMU series connection
SMU parallel connection
SMU series resistor
Re measurement, kelvin connection
Module 3 Leak current measurement
Ultra low current measurement
Id-Vg measurement
Gummel plot
Module 4 C-V sweep measurement
Module 5 Charge pumping
Flash memory
ALWG output
NOTE Demo.xpg file
Demo.xpg file is required to create the Demo preset group which contains the test setup
data used by the class exercises. And it is stored in the \data folder on Keysight B1500
Series Product Reference CD-ROM.
The Demo preset group should be created before starting the class exercise. To create the
preset group, launch EasyEXPERT and import the file by using the Preset Group Import
dialog box opened by clicking My Favorite Setup > Preset Group > Import Preset Group.
The test setup data are only examples for the class exercises.
Exercise Device Test setup/definition/data
MOSFET IDVD, Id-Vd
MOSFET Trace IdVd
MOSFET Trace IdVd
511 kohm IRVR
1 ohm Parallel
511 kohm IV-res
Bipolar Tr REKELV
- Zero-check
- Zero-check-ASU
MOSFET IDVG
Bipolar Tr GUMMEL
MOSFET CV-1MHz
MOSFET Charge Pumping 4T 0.1V
step
MOSFET Demo-S-NorFlash
Endurance
511 kohm ALWG monitor
Page
2-7
2-10
2-16
2-28
2-32
2-37
2-50
3-9
3-19
3-20
3-25
4-6
5-20
5-29
5-36