Keysight Technologies B1500A Self-Paced Training Manual page 178

Module 5
SPGU Control and Applications
This class exercise requires four jumper leads to connect the DUT. Connect the jumper leads
between the following terminals.
SMU1 : terminal 1
SMU2 : terminal 2
SMU3 : terminal 3
SMU4 : terminal 4
Then, the modules must be connected to the fixture as shown below.
B1500A SMU1 -> Fixture SMU1 connector
B1500A SMU2 -> Selector ch1 SMU input or ASU ch1 Force
B1500A SMU3 -> Selector ch2 SMU input or ASU ch2 Force
B1500A SMU4 -> Selector ch3 SMU input or ASU ch3 Force
B1500A PG2 -> Selector ch1 PGU input or ASU ch1 AUX In
B1500A PG3 -> Selector ch2 PGU input or ASU ch2 AUX In
B1500A PG4 -> Selector ch3 PGU input or ASU ch3 AUX In
Selector/ASU ch1 output -> Fixture SMU2 connector
Selector/ASU ch2 output -> Fixture SMU3 connector
Selector/ASU ch3 output -> Fixture SMU4 connector
5-30