Table of Contents
Advertisement
Flush-rear (recessed) mounting the device in the rack
4.
Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 26 Attaching the bracket extensions to the device
1.
Bracket extensions
Installing the device in the rack
Complete the following steps to install the device in the rack.
1.
Position the device in the rack, as shown in
to the rack.
2.
Attach the right front bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use
the upper and lower holes in the bracket.
3.
Attach the left front bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
46
Figure
27, providing temporary support under the device until the rail kit is secured
2.
Screws, 8-32 x 5/16-in., flathead Phillips
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00
Advertisement
Table of Contents
