Extreme Networks ExtremeSwitching VDX 6740 Hardware Installation Manual page 78

Installing the Universal Two-Post Rack Kit (XBR-R000294)
3. Attach the left front bracket to the left rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts.
Use the upper and lower holes in the bracket.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb. (29 cm-kg).
FIGURE 55 Attaching front brackets to a rack
1. Screws, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the rack
Complete the following steps to attach the rear brackets to the rack.
1. Select the proper length bracket for your post width. If your posts are three to five inches wide, use the brackets marked 3-5
INCH. If your posts are five to six inches wide, use the brackets marked 5-6 INCH.
2. Position the right rear bracket in the right rear of the device, as shown in
3. Attach the bracket to the right rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the upper and
lower holes in the bracket.
4. Repeat step 2 and step 3 to attach the left rear bracket to the left rack upright.
78
2. Retainer nuts, 10-32
Figure 56.
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00