Attaching The Rear Brackets To The Rack - Extreme Networks ExtremeSwitching VDX 6740 Hardware Installation Manual

Installing the 1U, 1.5U, and 2U Mid-Mount Kit for Two-Post Racks (XBR-000165, XBR-000175, and XBR-R000292)
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs)
FIGURE 33 Attaching the device to a rack
1. Bracket, front right
2. Screw, 10-32 x 5/8-in., panhead Phillips
3. Retainer nut, 10-32

Attaching the rear brackets to the rack

NOTE
Do not use the rear brackets for the Extreme Networks 6505, 6510, or 6520 switches.
Complete the following steps to attach the rear brackets to the rack.
1. Position the right rear bracket in the right rear of the device as shown in the following figure.
2. Attach the brackets using three 10-32 x 5/8-in. screws and 10-32 retainer nuts.
3. Repeat step 1 and step 2 to attach the left rear bracket.
54
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00