Table of Contents
Advertisement
Flush-front mounting the device in the rack
NOTE
Illustrations in these rack installation procedures are for reference only and may not show the actual device that you are
installing.
Complete the following tasks to install the device in a four-post rack:
1.
Attaching the front brackets
2.
Attaching the bracket extensions to the device
3.
Installing the device in the rack
4.
Attaching the rear brackets to the extensions
5.
Attaching the rear brackets to the rack posts
Attaching the front brackets
Complete the following steps to attach the front brackets to the device.
1.
Position the right front bracket with the flat side against the right side of the device at the front of the device, as shown in
19.
2.
Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on the
side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3.
Repeat Step 1 and Step 2 to attach the left front bracket to the left side of the device.
38
on page 38
on page 39
on page 40
on page 41
on page 43
ExtremeSwitching VDX 6740 Hardware Installation Guide
Figure
9036108-00
Advertisement
Table of Contents
