Extreme Networks ExtremeSwitching VDX 6740 Hardware Installation Manual page 79

5. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb. (29 cm-kg).
FIGURE 56 Attaching the rear brackets to a rack
1. Retainer nuts, 10-32
2. Rear brackets
Attaching the rear brackets to the device
Complete the following steps to attach the rear brackets to the device.
1. Align the right rear bracket to the right rear of the device and use four 8-32 x 5/16-in. panhead screws to attach the bracket to
the device, as shown in
2. Align the left rear bracket to the left rear of the device and use four 8-32 x 5/16-in. panhead screws to attach the bracket to the
device. Again, use the upper and lower slots in the bracket.
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00
Figure 57. Be sure to insert the screws through the upper and lower slots in the bracket.
Installing the Universal Two-Post Rack Kit (XBR-R000294)
3. Screws, 10-32 x 5/8-in., panhead Phillips
79