Installing The Engine Into A Rack - Extreme Networks Extreme Management Center NMS-A-25 Installation Manual

1. Lock the right end of the front bezel to the rack handle.
2. Rotate the front bezel clockwise till the left end clicks into place.
3. Lock the bezel, if needed.

Installing the Engine into a Rack

A rack mounting kit and installation guide are included with the NMS-A-25
engine. The rack mounting kit allows you to install the engine into a four-post
rack cabinet. Refer to the installation guide for complete installation instructions.
If you are table mounting the engine, ensure at least 6 cm (2.4 in) of clearance on
all sides of the engine for proper ventilation.
If you are installing the engine in a rack:
1. Install the rack handles by aligning a rack handle with the two holes on each side of
the engine and attaching each handle to the engine with two screws as shown in the
figure below.
Installing the Rack Handles
2. Read the installation guide included with the rack mounting kit.
3. Install the rails and mount the controller in the rack as instructed.
Installing the Engine into a Rack
13 of 34