Extreme Networks ExtremeSwitching VDX 6740 Hardware Installation Manual page 65

4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 42 Attaching the front brackets
1. The device
2. Front brackets
Attaching the bracket extensions to the device
Complete the following steps to attach the extension brackets to the device. There are medium and long extension brackets that you can
use for this step.
1. Select the proper length bracket extension for your rack depth.
2. Position the right bracket extension along the side of the device as shown in
3. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket extension and then into the holes
on the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
4. Repeat step 2 and step 3 to attach the left bracket extension to the left side of the device.
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00
Installing the Universal Four-Post Rack Kit (XBR-R000296)
3. Screws, 8-32 x 5/16-in., flathead Phillips
Figure 43.
65