Parameters; Operators - Control Techniques UD70 User Manual

4.4

Parameters

There are two types of parameter, as follows:
• Drive parameters
• Virtual parameters
(See Chapter 10 Parameters.)
Parameters are denoted by a # # (hash) symbol and are accessed using an x x ,y y
format, where x x represents the menu and y y represents the parameter in the
menu.
For example, parameter p7.05
accessed by entering #18.01
omitted, eg. #7.5
Parameters can also be accessed indirectly using an integer variable to
denote the parameter number. See Parameter pointers later in this chapter
for details.
4.5

Operators

Operators perform mathematical or logical operations on values. The
following operators are supported in DPL programming.
Note
Certain operators work only with integer values
or variables.
Operators for floating-point and integer variables
+
–
/
*
UD70
Issue code: 70nu2
p7.05 is accessed by entering #07.05
#18.01. Leading zeroes in the parameter can be
#7.5 is the same as #07.05 #07.05.
Plus
Minus
Divide
Multiply
DPL programming
#07.05, and p18.01 p18.01 is
4-5