Configuring The System - Control Techniques UD70 User Manual

2.2

Configuring the system

Host PC connections
The
RS232 Port
RS232
female D-type connector. Ready-made cables for
communications are generally available.
The table below gives the minimum required connections between the
and a 9-way and 25-way pin
UD70
pin no.
2
3
5
The
RS232
protection of the port is not included.
Use the following instructions for connecting a host
Ensure no static charge has built up when the plug is inserted.
1
Using a maximum cable length of not more than 3 metres (10 feet),
2
connect an
communications serial port of the host
Installing the DPL Toolkit in the host PC
Use either of the following procedures:
Windows 3.1
The DPL Toolkit requires a minimum of 4Mb of computer memory. This may be
virtual memory. Virtual memory may be set in the 386
Control Panel.
Start Microsoft Windows
1
Insert disk 1 of the DPL Toolkit into the
2
In Windows Program Manager, select File
3
Type
4
Click on
5
Windows 95
Insert disk 1 of the DPL Toolkit into the A: A: of the host PC.
1
In the
2
Type
3
Click on
4
2-2 Installation
serial port is a dedicated link to the host
port connector.
COM
9-pin connector
pin no.
2
3
5
port should be used only for commissioning because isolation or
cable to the
RS232 RS232
386 Enhanced
.
A:\SETUP
menu, select R R un...
.
A:\SETUP
. The port is a 9-way
PC
serial
RS232
25-pin connector
pin no.
3
2
7
:
PC
serial port on the
UD70
.
PC
Enhanced section of Windows
Drive of the host
A: PC
File on the menu bar. Select Run
un....
Issue code: 70nu2
UD70
and to the
or
RAM
.
Run.
UD70