Memory; Pc Requirements; Technical Data For The Ud70; User Knowledge - Control Techniques UD70 User Manual

UD70 connected to a host computer by a serial link
1.2

Memory

The compiled
stored in non-volatile
memory allows the programs to be loaded using the serial port.
Latest versions of programs can be easily updated without removing any
integrated circuits or without using any specialized programming equipment.
The filing system of the
at any one time.
UD70
The compiled program can be stored along with the DPL source code. This
allows the site engineer to read the program stored in the
program is not on the host
1.3

PC requirements

The minimum minimum requirement for the DPL Toolkit is as follows:
IBM AT
A 486
1.4

Technical data for the UD70

Intel 960 32-bit
96kb of user program storage
8kb user
16MHz clock
RS232
RS485
1.5

User knowledge

This User Guide assumes that the user has at least superficial knowledge of
Microsoft® Windows™. Refer to the Windows User's Guide for specific
information on performing operations in Windows™.
1-2 Introduction
program and the user-created source program are
UD70
memory on the
EEPROM
allows only one program to be stored in the
UD70
. (This option can be disabled if it is not required.)
PC
compatible 386SX , Windows™ 3.1, 4Mb
PC
with 8MB is recommended
PC RAM
processor
RISC
RAM
port for programming (
IBM AT
optically isolated port for permanent serial communications
card. This type of
UD70
, even if the
UD70
, 5
RAM DOS
compatible)
Issue code: 70nu2
UD70