Page 1
User Guide: Communications module Profinet Profibus Modbus TCP Modbus RTU Ethernet/IP DeviceNet For use with D1/D2 soft starters...
Page 2
Product Compatibility This communications module is suitable for use with Digistart D1 and D2 soft starters. For the latest manuals and software, please visit our website.
USB Module Disclaimer Contents Disclaimer .......................... 1 Important User Information ....................1 Introduction ........................2 Installation ......................... 2 Connection ........................3 Configuration ........................3 Specifications ........................4 Disclaimer The examples and diagrams in this manual are included solely for illustrative purposes.
Introduction USB Module Introduction The USB Module lets the soft starter connect to a PC, allowing the starter to be configured via dedicated management software. These instructions detail the installation, set-up and configuration of the USB Module. For details on using the management software, refer to the software help file.
1. Remove control power and mains supply from the soft starter. 2. Attach the module to the soft starter. 3. Connect the module to the PC via a USB cable. The PC should detect the module and the Hardware Update Wizard will open.
The starter may trip on Starter Comms while the Master is off-line. Reset the soft starter and place the Master on-line. NOTE The drivers will configure the USB port that the module is connected to. You must use the same physical USB port every time you connect the module to the PC. Specifications •...
Page 7
USB Module Specifications • Settings Protocol ................... AP Binary or AP ASCII Address ........................Data rate (bps) ..................... 9600 User Manual...
Need help?
Do you have a question about the USB and is the answer not in the manual?
Questions and answers
How do I set the USB to power down when the TV is turned off?