3D Menu - Digital Projection E-Vision Laser 7500 Series User Manual

Digital Projection E-Vision Laser 7500 & 8500 Series

3D menu

Use this menu to enable, disable and set up 3D input, as follows:
•
— , ,
3D Format Off Auto Side by Side (Half)
.
Frame Sequential
•
DLP Link — Off / On .
DLP Link On emits a sync pulse for the 3D glasses via the projected image.
will send the sync pulse to the sync out connector to use with an
DLP Link Off
external third party emitter.
•
— and
Eye Swap Normal Reverse
are displayed in the wrong order)
•
Dark Time — 0.65 ms , 1.3 ms
overlapping while the glasses are switching.
3D Sync
•
Offset — use the LEFT and RIGHT
processing delays in the projector.
•
— ,
Reference External Internal
Operating Guide
, T ,
op and Bottom Dual Pipe
(set to if the left- and right-eye images
Reverse
and 1.95 ms . Set to reduce the effect of images
arrow buttons to compensate for signal
and .
Auto
USING THE PROJECTOR
3D
3D Format
and
DLP Link
Eye Swap
Dark Time
3D Sync
Offset
Reference
Auto
For further information about
Off
supported 3D formats, see
Normal
connections
1.95 ms
Guide.
If 3D Format
3D settings will be unavailable.
100
Some settings may be unavailable
Internal
depending on other settings. For
more information, see
Combinations Of Settings
in this guide.
Frame Sequential is supported on
the HDMI, DVI-D and DisplayPort
inputs only.
3D video is only possible on the
HDMI, HDBaseT, DisplayPort and
DVI inputs.
The Frame Packing format is
automatically detected by the
projector.
See also
settings explained
guide.
Notes
3D
in the Connection
is set to Off , all other
Possible
further
3D types and Some 3D
further in this
Rev B September 2016
page 58