Table of Contents
Advertisement
Digital Projection E-Vision 6900 Series
3D menu
Use this menu to enable, disable and set up 3D input, as follows:
•
—
,
,
3D Format
Off
Auto
Side by Side
.
Frame Sequential
•
DLP Link
—
On
(if you are using 3D glasses that can utilise the
DLP Link® signal embedded in the image) and
•
Eye Swap
—
Normal
and
Reverse
right-eye images are displayed in the wrong order)
•
— set to 96Hz or 144Hz depending on the
3D 24Hz Display
source. This setting is disabled unless a 24Hz 3D input is detected.
•
Sync Reference
— set to
Internal
•
— this setting is only available if
Sync Delay
set to
.
External
Set a value between 0 and 100 ms.
The 3D Swap setting explained
The outgoing 3D frames are in pairs - the dominant frame being
presented first. You can determine which frame should be the dominant
one.
By convention the default setting is
Left
Operating Guide
, T
and
op and Bottom
Off
(set to
Reverse
if the left- and
or
External
as required.
is
Sync Reference
.
USING THE PROJECTOR
3D >>
3D Format
DLP- Link
Eye Swap
3D 24Hz Display
Sync Reference
Sync Delay
Select Item
Adjust
Dominance Left
LEFT 1
RIGHT 1
LEFT 2
RIGHT 2
Dominance Right
RIGHT 1
LEFT 1
RIGHT 2
LEFT 2
Off
If
3D Format
Off
no 3D signal is detected in
Normal
mode, the other 3D settings will be
144 Hz
unavailable.
Internal
Frame Sequential is supported on
0
the DVI input only.
3D video is only possible on the
HDMI, HDBaseT and DVI inputs.
The Frame Packing format is
[EXIT] Back
automatically detected by the
projector.
See also
guide.
LEFT 3
RIGHT 3
RIGHT 3
LEFT 3
Notes
is set to
, or if
Off
Auto
3D types
further in this
Rev A February 2017
page 40
Advertisement
Table of Contents
