3D Menu - Digital Projection HIGHLITE 660 3D series User Manual

Digital Projection
HIGHlite 660 3D Series

3D menu

•
Set 3D Enable to On or Off as required.
•
Use the Frame Rate Multiplier
frame rate.
For example, a 48 Hz frame rate could be tripled to 144 Hz.
•
3D Type should be set to Auto , except when the projector has problems selecting between
Sequential , Frame Packing , Top and Bottom
•
Set the to reduce the ghosting that can be caused by the images overlapping whilst
Dark Time
the glasses are switching.
•
Set the to compensate for signal processing delays in the projector.
Sync Offset
•
Set the Output Sync Polarity to suit the glasses, or if the left and right images appear to be
swapped.
•
Set to
Source Dominance Left
L R
L
R
Frame Packing
Rev A December 2013
to reduce flicker when the incoming 3D video signal has a low
and Side by Side (Half)
or to suit the incoming 3D video signal.
Right
L
Sequential
L
R
Top-and-Bottom
USING THE PROJECTOR
.
R
L R
Side-by-Side (Half)
Operating Guide
Notes
Main Menu
3D
When using frame rate
multiplication, the final output frame
rate must not exceed 144 Hz.
Set the Dark Time to the value
appropriate to the glasses or
ZScreen.
Adjust the Sync Offset to eliminate
ghosting and achieve a smooth
grayscale.
For additional information on 3D
Some 3D settings
settings, see
explained further in this section.
70