3D Menu - Digital Projection Titan Super Quad Series User Manual

Digital Projection
Titan Quad & Titan 800 Series

3D menu

•
Set 3D Enable to On or Off as required.
•
Use the Frame Rate Multiplier
frame rate.
For example, a 48Hz frame rate could be tripled to 144Hz.
•
3D Type should be set to Auto , except when the projector has problems selecting between
Sequential , Frame Packing , Top and Bottom
•
Set the to reduce the ghosting that can be caused by the images overlapping whilst
Dark Time
the glasses are switching.
•
Set the to compensate for signal processing delays in the projector.
Sync Offset
•
Set the Output Sync Polarity to suit the glasses, or if the left and right images appear to be
swapped.
•
Set to
Source Dominance Left
L R
L
R
Frame Packing
Rev F November 2012
to reduce flicker when the incoming 3D video signal has a low
and Side by Side (Half)
or to suit the incoming 3D video signal.
Right
L
Sequential
L
R
Top-and-Bottom
A TOUR OF THE MENUS
.
R
L R
Side-by-Side (Half)
Operating Guide
Notes
Main Menu
3D
Set the Dark Time to the value
appropriate to the glasses or
ZScreen.
Adjust the Sync Offset to eliminate
ghosting and achieve a smooth
grayscale.
For additional information on 3D
settings, see the Reference Guide.
The information on this page does
not apply to 2D projectors.
Op 15