3D Menu - Digital Projection HIGHlite 660 3D Series Installation And Quick Start Manual

Digital Projection HIGHlite 660 3D Series

3D menu

•
Set to or as required.
3D Enable On Off
•
Use the Frame Rate Multiplier to reduce flicker when the incoming 3D video signal has a low
frame rate.
For example, a 48 Hz frame rate could be tripled to 144 Hz.
•
should be set to , except when the projector has problems selecting between
3D Type Auto
, ,
Sequential Frame Packing Top and Bottom
•
Set the Dark Time to reduce the ghosting that can be caused by the images overlapping whilst
the glasses are switching.
•
Set the Sync Offset to compensate for signal processing delays in the projector.
•
Set the to suit the glasses, or if the left and right images appear to be
Output Sync Polarity
swapped.
•
Set Source Dominance to Left or Right
L R
L
R
Frame Packing
Operating Guide
and .
Side by Side (Half)
to suit the incoming 3D video signal.
L
Sequential
L
L
R
Top-and-Bottom
USING THE PROJECTOR
R
R
Side-by-Side (Half)
Notes
Main Menu
3D
When using frame rate
multiplication, the final output frame
rate must not exceed 144 Hz.
Set the Dark Time to the value
appropriate to the glasses or
ZScreen.
Adjust the Sync Offset to eliminate
ghosting and achieve a smooth
grayscale.
For additional information on 3D
Some 3D settings
settings, see
explained further in this section.
Rev E February 2015
page 75