3D Menu - Digital Projection M-Vision 18K Series Installation And Quick Start Manual

Digital Projection M-Vision Laser 18K Series

3D menu

Use this menu to enable, disable and set up 3D input, as follows:
•
, Side-bySide (half), Top and Bottom,
3D Format — Off , Auto
Frame Sequential
.
Frame Sequential
is displayed at the incoming rate whereas
sources where Left and Right eye are delivered on separate inputs.
•
DLP Link — Off / On .
DLP Link On
emits a sync pulse for the 3D glasses via the projected image.
Link Off
will send the sync pulse to the sync out connector to use with an external
third party emitter.
•
Eye Swap Normal Reverse
— and
are displayed in the wrong order)
•
Dark Time 0.65 ms 1.3 ms
— ,
image overlapping when viewed through 3D the glasses.
3D Sync
•
Offset — use the LEFT and RIGHT
overlappng (ghosting) when viewed through 3D glasses.
•
Reference External Internal
— and
Operating Guide
Dual Pipe
Reverse
(set to if the left- and right-eye images
1.95 ms
and . Set to reduce the eff ect of banding and
arrow buttons to compensate for image
. This is information only.
USING THE PROJECTOR
3D Format
DLP Link
Dual Pipe and
Eye Swap
Dark Time
is for
3D Sync
DLP
Offset
Reference
3D
.
Auto
If
Off
3D settings will be unavailable.
Normal
For further information about
1.95 ms
supported 3D formats, see
connections
Guide.
100
When 3D is on, the following
Internal
settings become unavailable:
•
•
•
See also 3D types See also
settings explained further in this settings explained
guide. guide.
See
Signal Input Modes > 3D formats
in the Reference Guide for 3D
resolutions and frame rates.
Notes
3D Format is set to Off , all other
3D
in the Connection
Image > Picture Mode
,
Dynamic Black,
Freeze
.
Geometry > Digital Zoom
,
Overscan
.
PIP >
all settings.
3D types and and Some 3D Some 3D
further in this
Appendix B: Supported
Rev D October 2019
page 62