Menu 1.3 Select Register; Menu 1.3.1 Register Readout And Selection - Hardi HC5500 Instruction Book

Menu 1.3 Select register

Menu 1.3.1 Register readout and selection

Register 1 to 98 can be used for individual areas.
Register 99 is a tally of register trips 1 to 98. They are identified with a
number and it is also possible to name them. The active register is
always visible in the right upper corner of the display. The data is
memorised when the system is switched off.
To read the totals of all registers
Shortcut
Press and hold until menu [1.3.1 Register XX] is shown.
Press or to go to register 99. The number is shown on the 1st line and if present, the name on the 4th line.
Press to enter the register.
Press to scroll through the data.
Press and hold to exit the menu system.
To read the data in the active register
Shortcut
Press and hold until menu [1.3.1 Register XX] is shown.
Press to enter register.
Press to scroll through the data.
Press and hold to exit the menu system.
To reset register
Press and hold until the countdown has ended.
Reset of a register can be stopped if the
To change the register
Shortcut
Press and hold until menu [1.3.1 Register XX] is shown.
Press or to change the register.
The number is shown on the 1st line and if present, the name on the 4th line.
Press . If necessary, the register can be reset.
Press until the countdown has ended.
Press and hold to exit the menu system.
μ
ATTENTION! The active register number is always visible in the right upper corner of the display.
μ
ATTENTION! Naming of registers are done in menu 2.6.
key is released before countdown has ended.
5 - Menu 1 Daily settings
1.3.1
SELECT REGISTER
Register XXXXX
29