Table of Contents
Advertisement
11.4
Storage conditions
m Suitable packaging for the CANsync-Master option module; if possible, the original
m Cover plate to cover the slot.
m Suitable tools for pulling out the board (e.g.pointed electronic pliers)
Carry out dismantling in the following sequence:
1 Deenergize the b maXX 4400 basic unit and secure it from unintentional switch-on.
2 Wait ten minutes (the capacitors discharge).
3 Open the switching cabinet.
4 Remove the b maXX 4400 basic unit's cover.
5 Remove the male connectors from the sockets.
6 Turn the spagnolet locks above and below the CANsync-Master option module's front
CAUTION
The following may occur, if you do not observe this caution information:
m property damage.
Danger from: electrostatic discharge. The electronic components on the PCB can be dam-
aged or destroyed if you touch them with your hands.
Only touch the CANsync-Master option module by the handle on the front panel.
7 Pull the CANsync-Master option module by the handle forwards out of the b maXX ba-
8 Place the module in the prepared packaging – when doing this, only touch the plug-in
9 Now fit a cover (or a new CANsync-Master option module for b maXX PLC) in the open
10 Turn the spagnolet locks by 90° (in the vertical position the locks are fastened).
11 Remount the cover on the unit.
12Close the switching cabinet.
13Document in writing dismantling (or replacing) the CANsync-Master option module.
You can now switch the unit back on. If you want to dispose of the module, refer to chapter
ZDisposal –
11.4 Storage conditions
Store the CANsync-Master option module for b maXX PLC in suitable packaging accord-
ing to the storage conditions in
11.5 Recommissioning
If you want to recommission the CANsync-Master option module for b maXX PLC, ob-
serve the storage conditions in
commissioning again.
42
Operating Instructions CANsync-Master Option Module for BM4-O-PLC BM4-O-CAN-06
Document No.: 5.02056.01A
von 56
packaging.
panel slot by 90° (in the horizontal position, they are unlocked).
sic unit.
module by the handle.
slot (the handle must be pointing toward the right-hand side of the unit).
from page 43 onward for more information.
ZTechnical Data –
from page 53 onward.
ZTechnical Data –
from page 53 onward. Then, carry out
Baumüller Nürnberg Electronic GmbH & Co. KG
Advertisement
Table of Contents
