Commissioning Sequence; Activation; Testing The Function - Baumuller BM4-O-CAN-06 Operating Instructions Manual

Cansync-master option module for bm4-o-plc

Table of Contents

6.5

Commissioning sequence

To find out how to eliminate the cause of the error, refer to

turbances –

6.5

Commissioning sequence

Commissioning is divided into the following procedures:

6.5.1

Activation.

m Read and observe the

m You must have carried out correctly section "Assembly and Installation".

m Switch on the b maXX 4400 basic unit.

NOTE

You must not remove or plug in the CANsync-Master option module while the b maXX 4400

basic unit is switched on. Switch the unit off first.

6.5.2

Testing the function

After activation, the LEDs flash one after the other (as described in

tializing –

If a complete application is present, LED H1 then shows receiving and sending of mes-

sage frames on the CANsync bus.

Operating Instructions CANsync-Master Option Module for BM4-O-PLC BM4-O-CAN-06

Document No.: 5.02056.01A

von 56

from page 35 onward.

ZGeneral safety regulations –

on page 31).

ZFinding and eliminating dis-

from page 29 onward.

Baumüller Nürnberg Electronic GmbH & Co. KG

ZActivating and ini-

Table of Contents