Table of Contents
Advertisement
2.7
Personnel training
WARNING
The following may occur, if you do not observe this warning information:
m serious personal injury
Only qualified personnel are allowed to mount, install, operate and maintain equipment
made by Baumüller Nürnberg Electronic GmbH & Co. KG.
Qualified personnel (specialists) are defined as follows:
Qualified Person-
Electrical engineers and electricians of the customer or of third parties who are authorized
nel
by Baumüller Nürnberg Electronic GmbH & Co. KG and who have been trained in install-
ing and commissioning Baumüller drive systems and who are authorized to commission,
ground and mark circuits and equipment in accordance with recognized safety standards.
Qualified personnel has been trained or instructed in accordance with recognized safety
standards in the care and use of appropriate safety equipment.
Requirements of
The drive system may only be operated by persons who have been trained and are au-
the operating staff
thorized.
Only trained personnel are allowed to eliminate disturbances, carry out preventive main-
tenance, cleaning, maintenance and to replace parts. These persons must be familiar
with the Operating Instructions and act in accordance with them.
Commissioning and instruction must only be carried out by qualified personnel.
2.8
Safety measures in normal operation
h At the unit's place of installation, observe the applicable safety regulations for the plant
h Provide the unit with additional monitoring and protective equipment if the safety reg-
h Observe the safety measures for the unit in which the plug-in module is installed.
2.9
Responsibility and liability
To be able to work with this CANsync-Master option module in accordance with the safety
requirements, you must be familiar with and observe the hazard information and safety
instructions in this documentation.
2.9.1
Observing the hazard information and safety instructions
In these operating instructions, we use visually consistent safety instructions that are in-
tended to prevent injury to people or damage to property.
Operating Instructions CANsync-Master Option Module for BM4-O-PLC
in which this unit is installed.
ulations demand this.
Basic Safety Instructions
m death
BM4-O-CAN-06
2
13
von 56
Advertisement
Table of Contents
