Table of Contents
Advertisement
2.5
Inappropriate Use
2.5
Inappropriate Use
Below, we will list some examples of inappropriate use. The information below should
give you an idea of what is meant by inappropriate use of the plug-in module. We cannon,
however, list all possible cases of inappropriate use here. Any and all applications in
which you ignore the information in this documentation are inappropriate; particularly, in
the following cases:
m You installed the plug-in module in units that are not Series b maXX 4400.
m You ignored information in these operating instructions.
m You did not use the plug-in module as intended.
n You handled the plug-in module as follows
m You modified the plug-in module without written permission from Baumüller Nürnberg
m You ignored the maintenance instructions in the component descriptions.
m You incorrectly combined the plug-in module with third-party products.
m You combined the drive system with faulty and/or incorrectly documented third-party
m Your self-written PLC software contains programming errors that lead to a malfunction.
Version 1.1 of Baumüller Nürnberg Electronic GmbH & Co. KG's General Conditions of
Sale and Conditions of Delivery dated 2/15/02 or the respective latest version applies in
all cases. These will have been available to you since the conclusion of the contract at
the latest.
2.6
Protective equipment
In transit, the plug-in modules are protected by their packaging. Do not remove the plug-
in module from its packaging until just before you intend to mount it.
The cover on the b maXX units' controller sections provides IP20 protection to the plug-
in modules from dirt and damage due to static discharges from contact. This means that
you must replace the cover after successfully mounting the plug-in module.
12
Operating Instructions CANsync-Master Option Module for BM4-O-PLC BM4-O-CAN-06
Document No.: 5.02056.01A
von 56
m you mounted it incorrectly,
m you connected it incorrectly,
m you commissioned it incorrectly,
m you operated it incorrectly,
m you allowed non-qualified or insufficiently qualified personnel to mount the module,
commission it and operate it,
m you overloaded it,
n You operated the module
m with defective safety devices,
m with incorrectly mounted guards or without guards at all,
m with non-functional safety devices and guards
m outside the specified environmental operating conditions
Electronic GmbH & Co. KG.
products.
Baumüller Nürnberg Electronic GmbH & Co. KG
Advertisement
Table of Contents
